Printing and Tech. Support
This forum contains 1,210 topic and 4,811 reply, and was last updated by 
-
- Forum
- Topics
- Posts
- Freshness
-
-
Printing planes
Advice about thin wall printing, FFF profiles, slicing software, filaments…
- 433
- 2,248
- 15 hours, 17 minutes ago
-
Assembly, finishing
Topics about glueing, hinges, pushrods, surface finish, reinforcing, balancing, repairs...
- 114
- 454
- 2 days ago
-
3D printers
All about printing hardware, hotends, extruders, nozzles...
- 65
- 530
- 5 days, 20 hours ago
-
RC equipment
Tips for motors, ESCs, transmitters and receivers, servos, retracts…
- 62
- 261
- 2 weeks, 5 days ago
-
Customizations
Share your own improvements of 3DLabPrint planes.
- 36
- 139
- 1 week, 4 days ago
-
Printing planes
-
- Topic
- Voices
- Posts
- Freshness
-
-
Help with printing…
1
2
3
…
17
18
19
Started by:
Stepan Dokoupil
- 96
- 277
- 3 weeks, 1 day ago
-
Cessna 152 elevator not slicing correctly
Started by:
- 2
- 3
- 5 hours, 4 minutes ago
-
PLA+/Tough PLA/Advanced PLA
Started by:
kmachman
- 1
- 1
- 1 day, 20 hours ago
-
This can’t be right…
Started by:
- 2
- 3
- 3 days, 23 hours ago
-
S3D and the print are leaving wide open spaces with Factory files.
Started by:
- 2
- 3
- 4 days, 12 hours ago
-
PI3_Edge_Ha_Elevator print issue with the center Pieces.
Started by:
fx2121.paul
- 1
- 1
- 4 days, 22 hours ago
-
F4u Corsair – Too Heavy – Dremel Idea Builder 3D40 -Simplify 3D
Started by:
sdfavis
- 1
- 1
- 5 days, 4 hours ago
-
My 1st print
Started by:
jordi.basas13
- 1
- 1
- 2 weeks, 1 day ago
-
Ideamaker
Started by:
threesixonegraphix
- 2
- 2
- 3 weeks, 3 days ago
-
CR10 Finally Getting Amazing Results, had to use 185 temp
1
2
3
Started by:
Alex T
- 12
- 41
- 4 weeks ago
-
Tyres, result!
Started by:
mark.chapman34
- 1
- 3
- 1 month, 1 week ago
-
Help with printing…
1
2
3
…
17
18
19
You must be logged in to create new topics.