Edge 540 Rudder print improvement

Home Forum Printing and Tech. Support Customizations Edge 540 Rudder print improvement

This topic contains 2 replies, has 2 voices, and was last updated by Avatar cliffordclinch 11 months ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #52534
    Simon
    Simon
    Participant

    admin delete if not allowed
    I modified the rudder because for me the tube for the rudder axle would wobble when being printed and come out wrong.
    So this one has a piece of material supporting it.

    #52535
    Simon
    Simon
    Participant

    For some reason it would not upload my file, so trying again inside a zip

    Attachments:
    You must be logged in to view attached files.
    #54006
    Avatar
    cliffordclinch
    Participant

    I had similar problems with my rudder especially when I tried to print it in PETG but after many failures I managed to use a smaller diameter steel wire (0.6mm) my PLA print also has a 0.6mm wire next time when I print this model again in PLA (probably in a couple of weeks) I will try your supports idea thanks

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.