F-86 fuselage 4 probelem

Home Forum Printing and Tech. Support F-86 fuselage 4 probelem

Viewing 9 posts - 1 through 9 (of 9 total)
  • Author
    Posts
  • #53108
    AvatarSonnich Johannesen
    Participant

    Hi.

    I have a problem printing fuselage section 4 inner duct.
    It seems to be hanging almost freely in mid air and will ofcourse fail ?

    Attachments:
    You must be logged in to view attached files.
    #53114
    AvatarSonnich Johannesen
    Participant

    I have seperated the surfaces, so you can see the 2 problem parts ?

    Attachments:
    You must be logged in to view attached files.
    #53901
    AvatarJIM ASHBROOK
    Participant

    I have the same problem…..there is no support/connection to the outer structure. I have downloaded the files again and generated the gcode using Simplify3d with the same result.
    Fuselage parts 1,2, 3 and 5 print OK.

    #54311
    Avatarjimramey1
    Participant

    I am encountering the same issue at about 88 mm height.
    Is there any solution to this?
    The part is printing ok but there is definitely material missing for 1 layer in the inner structure.

    #54864
    AvatarAl Vecchio
    Participant

    Is this the area that is removed to make room for the fan.

    #55111
    AvatarWilliam Holland
    Participant

    It’s supposed to be this way, mine printed fine, but Fuse 5 is messing up

    #60125
    Avatarstefan-frank
    Participant

    I’m running in the same problem while printing fuselage part4 with simplify factory files. Is there a solution available?

    #1318483
    Avatarjakewallis
    Participant

    Any help on this I have the same issue?

    #1408853
    Avatartkosmidis
    Participant

    any news? having the same problem! did anyone find a solution?

Viewing 9 posts - 1 through 9 (of 9 total)
  • You must be logged in to reply to this topic.