I need settings for CR-10 and Simplify3D

Home Forum Printing and Tech. Support 3D printers I need settings for CR-10 and Simplify3D

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • #20774
    Avatar1760
    Participant

    Hello, i need settings for my CR-10 und Simplify3d. I have tried it many times, but it does not work for me. It is frustrating an many PLA is gone, but no success.
    Can anybody help me with settings for “plug and play” on a stock CR-10 please?

    #24003
    Avatarmartinrudat
    Participant

    finally i found some perfekt settings for a standard cr 10.
    watch time laps of the ailerons

    just have the cr 10 since a week, tried a lot till i was satisfied with the print quality. with retraction 6mm i still had strings.

    my best settings for the creality cr-10
    load original 3dlabprint factory file, change build volume to 300x300x400
    offset to 50x50x0
    extrusion multiplier 1,04 it makes it slightly heavier or keep default
    retraction 7mm
    retraction extra distance 0,10 mm
    temperature 240 C
    change layer to 0,2mm, takes longer looks nicer in transparent
    no strings or anything. print time for the a half wing about 20h!
    USED OCTOPI FOR THIS VIDEOS

    #24252
    Avataragostamassimiliano
    Participant

    Hello,
    I’m looking for good settings for the Creality CR-10S because I have the same bad results of “1760”.
    I follow your indications “martinrudat” but the result is again vary poor.
    The extruder seems that don’t flush the filament in a acotinuos way and at certain point a blob of material is deposited on the Plate, at the same time there are zone where the material is quite un-present.
    It’s really frustrating not be able to setup the printer to print the plane.

    Any suggestions ?

    thanks in advance

    Attachments:
    You must be logged in to view attached files.
    #25280
    Avatareffy1975
    Participant

    3dlab ask for 230 nozzle martinrudat uses 240
    i think its too much for PLA try to set 190-210
    it looks you are too hot

    #25735
    kevinkevin
    Participant

    Hi

    Try this for the cr10, fff file attached

    Kind Regards,
    Kevin.

    • This reply was modified 2 years, 1 month ago by kevinkevin.
    Attachments:
    You must be logged in to view attached files.
    #26160
    Avataragostamassimiliano
    Participant

    Hi Kevin,
    your posted .fff is fine to print the plane, I have use it and get good results.
    Wich kind of setup you use to print the accessories that require an INFILL setup?
    thanks
    Max

Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.