Interior structures showing through

Home Forum Printing and Tech. Support Interior structures showing through

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #62882
    Avatarben2
    Participant

    Hi All,

    This one has been asked before but I can’t see any answers… any ideas why the internal structures show through on my parts, it seems worse on the top left 1.4, bit less bottom left 1/4 and the right 1/2 isn’t bad at all….Printer’s a CR10s. I’ve attached a photo to show it, please all the Jedi’s, give me some clues??

    thanks Y’all…

    Attachments:
    You must be logged in to view attached files.
    #274157
    Avatargarybulmer100
    Participant

    for what its worth i have a CR-10 and have the same problem

    #290972
    Avatarcgwendling
    Participant

    If you are wanting flyable models, then that is exactly what the model will look like when done on models that don’t print in vase mode.
    Why? You ask. The inner structure printing has to tie into the outer perimeter somewhat to be a structurally sound part. This will show up on single perimeter prints.

Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.