Percentage fill for printing wing sections

Home Forum 3DLabGANG projects Kaier Falcon Percentage fill for printing wing sections

Tagged: , ,

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #51522
    AvatarDavid Russell
    Participant

    Hi,
    I am currently printing the wing sections for the Falcon as per the instructions but am unclear about the % infill that I should be using. Currently printing with 0% infill but I think it should be 100%.

    Could you clarify this for me please?

    Cheers,
    Dave (Australia)

    #51586
    minhzcminhzc
    Moderator

    Hi David,
    Please try with 20% infill. 100% infill is OK (not so different for the strength or weight) but it would take you more time.

    Regards.

Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.