Qtrainer tyre and disk

Home Forum Printing and Tech. Support Assembly, finishing Qtrainer tyre and disk

Tagged: 

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • #26960
    Avatargerd.lobmeyer
    Participant

    Hi, I am printing the last parts of the plain. All is perfect but I do not check how to assemble the tyre. The tyre hast a fold in the hole and the disk fits to the hole. So it is not possible to bring up the tire on the disk over the fold??
    Greetings
    Gerd

    #26963
    Avatargerd.lobmeyer
    Participant

    Ok, I think I found a hint. In the userguide of an other plane I saw that I have to buy flex filament….

    So it is solved.
    Regards
    Gerd

    #27049
    Avatargerd.lobmeyer
    Participant

    So, I got flexible filament and printed the tyre again. Is this the wrong filament?
    Flexfill 98A Traffic black filament 500g – Diameter : 1,75 mm

    Because I think without break the tyre I am not able to put it on the disk? Where is a manual to see how this is possible?

    Regards
    Gerd

    #27076
    apocalypsedudeapocalypsedude
    Participant

    I guess 98A means 98 Shore A. That’s pretty hard, scale goes only up to 100, which is the hardest.

    But don’t worry. Inside the tyre there should be a ridge, on which the wheel disc is supposed to click in.
    Just cut away this ridge and you will be able to mount the tyre on the disk. If necessary you can secure it with some drops CA glue.

    #29324
    Avatargreg.greene74
    Participant

    I used soft PLA for the tire
    Started the rim in it and placed them in a vise, tightened the vise and
    they went together perfectly

Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.